• Take out and clean espressogroup 37 & 44mm

      • Welcome

        This instruction will show you how to take out and clean the brewer.

      • Disconnect the espresso group connections

        1. Open the door
        2. Switch OFF the machine
        3. Remove the stainless steel cover
      • Disconnect the espresso group connections.

        • Remove the plastic slide. (earlier models of the slide are made from stainless steel).
      • Disconnect the espresso group connections

        1. Remove the lower hose (water supply) from the push-in fitting
        2. Remove the upper hose (coffee outlet) from the push-in fitting
      • Remove the espresso group from the machine

        1. Unscrew the knurled bolt with which the brewer is attached.
        2. Press down the plastic snap hook at the bottom take group from the drive unit.
        3. Take the group out of the machine
      • Remove the espresso group from the machine

        • Wash the brewer completely with (warm)water
        • Clean the upper piston and filter thoroughly
      • Function test

        • Run the brewer a few cycles by hand by rotating the drive wheel. 
        • Check if piston movements are moving in good order and without friction.
      • Replace the espresso group in the machine

        1. Slide the the knurled bolt into the espresso group.
        2. Position the right site of the group against the motor unit.
        3. Fixate the group with the knurled bolt. Do not over tighten it!

      • Re-connect the espresso group 

        • Place the coffee outlet hose (upper)
        • Plug in the lower tube (water supply).

      • Final checks 

        • Place plastic slide in the group.

      • Final checks

        1. Replace the stainless steel cover
        2. Switch ON the machine
        3. Close the door
        4. Take a few coffees to test the machine