• Install the cup dispenser

      • TECHNICAL DATA

        Tabletop cup dispensing cabinet with 3 cup dispensers. Easy to adjust for cup size Ø60 - 90 mm. Equipped with automatic cup press mechanism and removable ingredient box on top.

        Art. No. : 1010386

        Depth: 37,5 cm.

        Width: 14 cm.

        Height Rear end : 57 cm.

        Height Front side: 50 cm.

        Weight: .. Kg.

        Original instructions - published 08-2021

      • Check the contents of the package:

        • Cup dispenser
        • Rubber rings: 60-72 mm (2x), 72-82 mm (2x), 80-90 mm (2x)
        • Tyraps (6x)
      • Tools required for this instruction.

        • Screwdriver (crosshead)
        • Wire cutters
      • Pull the removable organiser insert off top.

      • Push the metal switch to the right.

      • Loosen the screws a little.

      • Lift the front slightly and pull it forward.

      • Pull the tube slightly out of the housing.

      • Cut the tyrap.

      • Remove the rubber ring from the tube.

        1. Measure the diameter of the cups to be used
        2. Choose the ring that matches the cups to be used
        • Small size cup: 60-74 mm.
        • Middle size cup: 75-82 mm.
        • Large size cup: 83-90 mm. 
      • Slide the correct rubber ring over red lid.

      • Slide the rubber ring over the tube.

      • Secure the rubber ring in the correct position with a tyrap.

        1. Secure the rubber ring with a tyrap.
        2. shorten the tyrap.
      • Slide the tube back.

        Repeat steps 8 - 16 for the other two tubes.

      • Place the front back on the housing.

      • Tighten the screws.

      • Turn the metal switch to the left to secure the cover.

      • Place the removable organiser insert back on top.

      • The cup dispender is ready to use.

    • Commissioning

      • Push the cups into the cup dispenser.

      • Fill the ingredient box on top.

      • The cup dispender is ready to use.